trivial: fix then -> than typos in comments and documentation
- (better, more, bigger ...) then -> (...) than
Signed-off-by: Frederik Schwarzer <[email protected]>
Signed-off-by: Jiri Kosina <[email protected]>
diff --git a/include/linux/mtd/mtd.h b/include/linux/mtd/mtd.h
index eae26bb..64433eb 100644
--- a/include/linux/mtd/mtd.h
+++ b/include/linux/mtd/mtd.h
@@ -83,7 +83,7 @@
* @datbuf: data buffer - if NULL only oob data are read/written
* @oobbuf: oob data buffer
*
- * Note, it is allowed to read more then one OOB area at one go, but not write.
+ * Note, it is allowed to read more than one OOB area at one go, but not write.
* The interface assumes that the OOB write requests program only one page's
* OOB area.
*/
diff --git a/include/linux/spi/spi.h b/include/linux/spi/spi.h
index 8222931..68bb1c5 100644
--- a/include/linux/spi/spi.h
+++ b/include/linux/spi/spi.h
@@ -327,9 +327,9 @@
* @tx_dma: DMA address of tx_buf, if @spi_message.is_dma_mapped
* @rx_dma: DMA address of rx_buf, if @spi_message.is_dma_mapped
* @len: size of rx and tx buffers (in bytes)
- * @speed_hz: Select a speed other then the device default for this
+ * @speed_hz: Select a speed other than the device default for this
* transfer. If 0 the default (from @spi_device) is used.
- * @bits_per_word: select a bits_per_word other then the device default
+ * @bits_per_word: select a bits_per_word other than the device default
* for this transfer. If 0 the default (from @spi_device) is used.
* @cs_change: affects chipselect after this transfer completes
* @delay_usecs: microseconds to delay after this transfer before
