ARM: dts: Use defined GPIO constants in flags cell for OMAP2+ boards
Many OMAP2+ DTS are not using the defined constants to express
the GPIO polarity. Replace these so the DTS are easier to read.
Signed-off-by: Javier Martinez Canillas <[email protected]>
Signed-off-by: Tony Lindgren <[email protected]>
diff --git a/arch/arm/boot/dts/omap4-sdp.dts b/arch/arm/boot/dts/omap4-sdp.dts
index dac86ed..f0bdc41 100644
--- a/arch/arm/boot/dts/omap4-sdp.dts
+++ b/arch/arm/boot/dts/omap4-sdp.dts
@@ -30,7 +30,7 @@
regulator-name = "VDD_ETH";
regulator-min-microvolt = <3300000>;
regulator-max-microvolt = <3300000>;
- gpio = <&gpio2 16 0>; /* gpio line 48 */
+ gpio = <&gpio2 16 GPIO_ACTIVE_HIGH>; /* gpio line 48 */
enable-active-high;
regulator-boot-on;
};
@@ -155,7 +155,7 @@
regulator-name = "vwl1271";
regulator-min-microvolt = <1800000>;
regulator-max-microvolt = <1800000>;
- gpio = <&gpio2 22 0>;
+ gpio = <&gpio2 22 GPIO_ACTIVE_HIGH>;
startup-delay-us = <70000>;
enable-active-high;
};
@@ -374,7 +374,7 @@
/* SPI = 0, IRQ# = 119, 4 = active high level-sensitive */
interrupts = <GIC_SPI 119 IRQ_TYPE_LEVEL_HIGH>; /* IRQ_SYS_2N cascaded to gic */
- ti,audpwron-gpio = <&gpio4 31 0>; /* gpio line 127 */
+ ti,audpwron-gpio = <&gpio4 31 GPIO_ACTIVE_HIGH>; /* gpio line 127 */
vio-supply = <&v1v8>;
v2v1-supply = <&v2v1>;
