spi: rspi: Remove set_config_register() macro
The set_config_register() macro is used in a single place.
Make the code easier to read by just removing it.
Signed-off-by: Geert Uytterhoeven <[email protected]>
Link: https://lore.kernel.org/r/[email protected]
Signed-off-by: Mark Brown <[email protected]>
diff --git a/drivers/spi/spi-rspi.c b/drivers/spi/spi-rspi.c
index e54a25f..9eabef3 100644
--- a/drivers/spi/spi-rspi.c
+++ b/drivers/spi/spi-rspi.c
@@ -426,8 +426,6 @@ static int qspi_set_receive_trigger(struct rspi_data *rspi, unsigned int len)
return n;
}
-#define set_config_register(spi, n) spi->ops->set_config_register(spi, n)
-
static void rspi_enable_irq(const struct rspi_data *rspi, u8 enable)
{
rspi_write8(rspi, rspi_read8(rspi, RSPI_SPCR) | enable, RSPI_SPCR);
@@ -940,7 +938,7 @@ static int rspi_prepare_message(struct spi_controller *ctlr,
if (spi->mode & SPI_LOOP)
rspi->sppcr |= SPPCR_SPLP;
- set_config_register(rspi, 8);
+ rspi->ops->set_config_register(rspi, 8);
if (msg->spi->mode &
(SPI_TX_DUAL | SPI_TX_QUAD | SPI_RX_DUAL | SPI_RX_QUAD)) {
