ACPI / ARM64 : use the new BAD_MADT_GICC_ENTRY macro
For those parts of the arm64 ACPI code that need to check GICC subtables
in the MADT, use the new BAD_MADT_GICC_ENTRY macro instead of the previous
BAD_MADT_ENTRY. The new macro takes into account differences in the size
of the GICC subtable that the old macro did not; this caused failures even
though the subtable entries are valid.
Fixes: aeb823bbacc2 ("ACPICA: ACPI 6.0: Add changes for FADT table.")
Signed-off-by: Al Stone <[email protected]>
Reviewed-by: Hanjun Guo <[email protected]>
Acked-by: Will Deacon <[email protected]>
Acked-by: "Rafael J. Wysocki" <[email protected]>
Signed-off-by: Catalin Marinas <[email protected]>
diff --git a/drivers/irqchip/irq-gic.c b/drivers/irqchip/irq-gic.c
index 8d7e1c8..4dd8826 100644
--- a/drivers/irqchip/irq-gic.c
+++ b/drivers/irqchip/irq-gic.c
@@ -1055,7 +1055,7 @@
processor = (struct acpi_madt_generic_interrupt *)header;
- if (BAD_MADT_ENTRY(processor, end))
+ if (BAD_MADT_GICC_ENTRY(processor, end))
return -EINVAL;
/*
