mm: add three more cond_resched() in swapoff
Add a cond_resched() in the unuse_pmd_range() loop (so as to call it
even when pmd none or trans_huge, like zap_pmd_range() does); and in the
unuse_mm() loop (since that might skip over many vmas). shmem_unuse()
and radix_tree_locate_item() look good enough already.
Those were the obvious places, but in fact the stalls came from
find_next_to_unuse(), which sometimes scans through many unused entries.
Apply scan_swap_map()'s LATENCY_LIMIT of 256 there too; and only go off
to test frontswap_map when a used entry is found.
Link: http://lkml.kernel.org/r/[email protected]
Signed-off-by: Hugh Dickins <[email protected]>
Reported-by: Eric Dumazet <[email protected]>
Cc: David Rientjes <[email protected]>
Signed-off-by: Andrew Morton <[email protected]>
Signed-off-by: Linus Torvalds <[email protected]>
diff --git a/mm/swapfile.c b/mm/swapfile.c
index f304389..1c6e032 100644
--- a/mm/swapfile.c
+++ b/mm/swapfile.c
@@ -1234,6 +1234,7 @@ static inline int unuse_pmd_range(struct vm_area_struct *vma, pud_t *pud,
pmd = pmd_offset(pud, addr);
do {
+ cond_resched();
next = pmd_addr_end(addr, end);
if (pmd_none_or_trans_huge_or_clear_bad(pmd))
continue;
@@ -1313,6 +1314,7 @@ static int unuse_mm(struct mm_struct *mm,
for (vma = mm->mmap; vma; vma = vma->vm_next) {
if (vma->anon_vma && (ret = unuse_vma(vma, entry, page)))
break;
+ cond_resched();
}
up_read(&mm->mmap_sem);
return (ret < 0)? ret: 0;
@@ -1350,15 +1352,12 @@ static unsigned int find_next_to_unuse(struct swap_info_struct *si,
prev = 0;
i = 1;
}
- if (frontswap) {
- if (frontswap_test(si, i))
- break;
- else
- continue;
- }
count = READ_ONCE(si->swap_map[i]);
if (count && swap_count(count) != SWAP_MAP_BAD)
- break;
+ if (!frontswap || frontswap_test(si, i))
+ break;
+ if ((i % LATENCY_LIMIT) == 0)
+ cond_resched();
}
return i;
}
