Rename target_phys_addr_t to hwaddr
target_phys_addr_t is unwieldly, violates the C standard (_t suffixes are
reserved) and its purpose doesn't match the name (most target_phys_addr_t
addresses are not target specific). Replace it with a finger-friendly,
standards conformant hwaddr.
Outstanding patchsets can be fixed up with the command
git rebase -i --exec 'find -name "*.[ch]"
| xargs s/target_phys_addr_t/hwaddr/g' origin
Signed-off-by: Avi Kivity <[email protected]>
Signed-off-by: Anthony Liguori <[email protected]>
diff --git a/hw/imx_serial.c b/hw/imx_serial.c
index d4eae43..dcd125f 100644
--- a/hw/imx_serial.c
+++ b/hw/imx_serial.c
@@ -183,7 +183,7 @@
}
-static uint64_t imx_serial_read(void *opaque, target_phys_addr_t offset,
+static uint64_t imx_serial_read(void *opaque, hwaddr offset,
unsigned size)
{
IMXSerialState *s = (IMXSerialState *)opaque;
@@ -244,7 +244,7 @@
}
}
-static void imx_serial_write(void *opaque, target_phys_addr_t offset,
+static void imx_serial_write(void *opaque, hwaddr offset,
uint64_t value, unsigned size)
{
IMXSerialState *s = (IMXSerialState *)opaque;
@@ -401,7 +401,7 @@
return 0;
}
-void imx_serial_create(int uart, const target_phys_addr_t addr, qemu_irq irq)
+void imx_serial_create(int uart, const hwaddr addr, qemu_irq irq)
{
DeviceState *dev;
SysBusDevice *bus;
@@ -427,7 +427,7 @@
qdev_prop_set_chr(dev, "chardev", chr);
bus = sysbus_from_qdev(dev);
qdev_init_nofail(dev);
- if (addr != (target_phys_addr_t)-1) {
+ if (addr != (hwaddr)-1) {
sysbus_mmio_map(bus, 0, addr);
}
sysbus_connect_irq(bus, 0, irq);
